新闻动态
·综合新闻
·科研动态
·学术活动
·媒体聚焦
·通知公告
您现在的位置:首页 > 新闻动态 > 学术活动
11.10】Jia-Hong Huang
题目:Evaluation of Fracture Toughness of ZrN Hard Coatings by Internal Energy Induced Cracking Method
 
2014-11-07 | 文章来源:环境功能材料研究部        【 】【打印】【关闭

题目Evaluation of Fracture Toughness of ZrN Hard Coatings by Internal Energy Induced Cracking Method

报告人Jia-Hong Huang (黃嘉宏)

Department of Engineering and System Science National Tsing Hua University Hsinchu, 300, Taiwan

时间20141110日 (周一) 1000-12:00

地点:李薰楼468会议室

Abstract

The objectives of this study were to evaluate the fracture toughness of ZrN hard coatings and to investigate the effects of preferred orientation and stress gradient on the fracture toughness. A recently developed energy-based method named internal energy induced cracking (IEIC) method was employed to measure the fracture toughness of ZrN hard coatings. ZrN film was continuously deposited until reaching the thickness at which the film was fractured due to stored energy accumulation. The residual stress before crack initiation was used to calculate the stored energy (GS), from which fracture toughness (GC) could be derived. The results showed that for a ZrN coating with (111) texture coefficient of 0.71, the fracture toughness was estimated to be ranged from 23.9 to 29.9 J/m2. Fracture toughness of ZrN coatings was related to both residual stress and preferred orientation, which were controlled by deposition parameters. With lower substrate bias, the residual stress and accompanying stored energy were lower and the texture remained strong (111), and therefore thicker ZrN coating could be deposited. As the film thickness was above 4.22 mm, the (200) orientation increased in the strongly (111) textured ZrN coatings, which could be associated with the release of stored energy. The stored energy in the ZrN coating was partly released, when the energy was higher than 31.6 J/m2, accompanying with the stress relief. The release of stored energy was considered to be the driving force of texture inversion. Stress gradient may play an important role in the fracture mode. The fracture could be initiated at a position of local maximum stress gradient along with defects. The fluctuating behavior in stress gradient was possibly owing to the accumulation and relaxation of residual stress during film growth, which may serve as a stress tuning mechanism in depositing thick coatings.

欢迎参加!

 

 

文档附件

相关信息
联系我们 | 友情链接
地址: 沈阳市沈河区文化路72号 邮编: 110016
运维邮箱: office@imr.ac.cn
中国科学院金属研究所 版权所有 辽ICP备05005387号-1

官方微博

官方微信